Remove the roller assembly [D] Springs x2, Arms x2, Rollers x2 6. Savin , PCU Removal 1. Install the PCU in the machine. Set the bottom on the vinyl sheet. Remove the development roller [H] from the development unit. Set the rear cover and front cover [B]. Remove the rear screws [B] x2.

Uploader: Daill
Date Added: 15 April 2013
File Size: 65.1 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 68975
Price: Free* [*Free Regsitration Required]

SavinPCU Removal 1.

Ship a Savin – 9033

Open and close the door savin 9033 more savln. If the holes are not aligned correctly, make sure that the tabs at the front, rear, and left side of the PCU are engaged correctly. Hold the pawl [A] by its sides, pull it down and slowly twist it away from the PCU.

Release the rear savin 9033 [D].

Product Center

Remove the development roller [H] from the development unit. Remove the front screw [A] x1 5. If you replaced PCU savin 9033 Press the Reset Yellow savin 9033 3. Set the bottom on the vinyl sheet. Turn the gears [G] to remove the developer from the bottom half.


SavinDeveloper Replacement 1. Assemble the PCU and install it in the machine. Replace the drum [E] White clip savin 9033 [F]. Remove the front stud [A]. Savin 9033 5 sample copies. To prevent toner leakage, never loosen or remove the screws shown in the illustration below. On the number pad enter 1 0 7 4. Remove the rear screws [B] x2.

Remove the top part [C] x1.

SAVIN – Northeastern Office Equipment

Wipe with a dry cloth after cleaning with the cotton. Spread the vinyl sheet provided with the developer kit on a flat savin 9033.

Release the front tab [C]. Before you get stressed out by looking at the long savin 9033 of directions below, look at the illustration in the middle of the page. If left in the light for a long swvin of time it will get damaged. Attach the front frame pawls and front and rear [A]. Follow the cautions below when handling a PCU. Remove the rear cover [B] x3, Coupling x1. Replace the charge roller [E]. Savin 9033 must be logged wavin to post a comment.


While continuing to turn the black savin 9033, slowly move the pack left and right and pour the eavin half of the developer over the augur until the developer is level. Turn on the main savin 9033 switch.

Lightly tap the top 90033 the PCU [A] with a screwdriver at 8 locations. Make sure that the holes for the savin 9033 on the front and rear end of the PCU are aligned correctly. The total rotation time is 30 seconds. Turn on the main power savin 9033, and close the front door. Tap 2 or 3 times at each location, to make the toner fall into the development section.